Multiboard Magnetic iFixit Mako Driver Kit Mount (Wall Mount)

A re-implementation of daveh_dev's magnetic mount for the iFixit Mako driver kit using Multiconnect for Multiboard and direct-to-wall compatibility. 

Like the original, this mount lets you to quickly grab the whole kit or just remove the lid to grab your required tools/bits. The design was also changed to use 10x3mm magnets, the ones I happened to have on hand.

Required Parts

• The provided 3D printed parts
  • The top bracket can be considered optional if you don't mind a less rigid mount or if you have very strong magnets
• Six 10x3mm magnets
• Super glue to glue the magnets
• Six of your Multiconnect connectors of choice (Multiboard, direct wall mount, etc.)
  • Four connectors for the bottom piece, two for the top.
  • While there are HSW Multiconnect connectors, this model will not work with the HSW due to the spacing of the connectors.

Printing Instructions

Print in the provided orientation (vertically), no support needed. A brim is recommended for the top bracket piece.

Other Mounts

If your Mako driver kit is from the iFixit Pro Tech Toolkit, see my other design for holding the remaining tool roll.

Re-modelled daveh_dev's original to use the Multiconnect system. The magnet layout and type was also changed.