Wera Bit Check Holder for ToughBuilt Technician 7-Pocket Pouch - Large

I wanted to attach my Wera Bit Check to my Toughbuilt Technician Pouch. So I made a holder that attaches to the side. 

I don't know if all 6 heatseat inserts are needed, but I havent had any issue with the one I made even after a year. 

Installing:

I used the drill jig as a guide for aligning, marking and punching/drilling the holes in the Toughbuilt Pouch. 

I attached them using low profile ¼" FHCS and heat inserts.

I had to cut down and modify a 5/32" allen key to be able to tighten the bolts.

Parts:

• (6) 1/4"-20 x .3" Long Heat Set Inserts
  • I used these from Amazon
• (6) 1/4"-20 x 3/8" long FHCS 
  • I used these from McMaster Car

Print Settings:

Material - I used PLA. (It has lasted for over a year)