A small case for your medication or other small items.
Consists of two parts: the lid and case itself.
There is also a hole in each part for magnets (3x1.5mm). Magnets are not required!
The lid closes good by itself but it might get worn out by using it a lot depending on your material, so just in case i put those there so you won't need to print another one and just add some magnets.
Height: 15 mm
Width: 24 mm
Lenght: 30 mm (top part), 27 mm (bottom part)
Inside height: 12 mm
Inside width: 20 mm
Inside lenght: 23 mm
The author marked this model as their own original creation.