Wago clamp shaped Wago clamp box

This is a giant Wago clamp box. You can store your Wago clamps in it or anything else that fits. It was printed in Fillamentum crystal clear and 3Djake neon orange. 

It prints without supports in the orientation shown. But adding some will improve the overhangs. To connect the levers simply push in a piece of 1.75mm filament through. Its a bit tricky. The levers have a sort of slight snap fit. 

I recommend printing the calibration part for the hole diameter to see which Version fits to your printer and the 1.75mm fileament. Then the corresponding STL files can be chosen. 

The Wago text can be printed separately and then glued in the lever.

Notice: the Wago logo and the Wago trademark are owned by WAGO GmbH & Co. KG.