Ender 3 NG Beta WIP Legs

I was looking for a simple lift kit for the Ender 3 NG, failing anything simple I found the lift kit by Jeremiah and hacked them in tinkercad to make them mount on the Beta Ender 3 NG seeing as it uses the 4040 in extrusion from the same kit. I added screw holes for a few points on the E3NG and added a filler section for the middle although it is not required. I needed to raise the printer so I could lower the z axis lead screw without cutting it off.

This is a WIP I am currently printing it out to test I may modify it in the future.

Edit: determined it would be difficult to install the z axis linear rod in the initial design so I modified the front leg to allow sliding it forwards after removing the mounting screws to line up with an installation hole for the linear rod. This rod is completely captured when the leg is slid into normal position.

this was a very tight fit for me, just as a warning :)

This is simply taking the lift kit by Jeremiah for the stock Ender 3 and modifying it to fit the modified Ender 3 NG Beta by RH3d.