Filament spool holder for Ikea SKADIS - End Stops Remix

I wanted a more low profile end bracket than the one the original author had. This design is a slip over the end design that has a hold down for the 22mm(7/8") dowel rods. 

I also made a center version that allows you to link two together in between two IKEA panels for additional strength and since I couldn't find any 7/8" wooded dowel rods longer than 4' locally. 

Additionally there is a hole in the top that allows you to drill a pilot hole into the wooden dowel rods, and then screw in a retention screw. 

I printed the end versions on their backs pointed up. I printed the center version on the top, long ways to give strength to it since it was connecting two bracket setups. 

I wanted a more low profile end bracket than the one the original author had.  I also made a center version that allows you to link two together in between two IKEA panels for additional strength.

Additionally there is a hole in the top that allows you to drill a pilot hole into the wooden dowel rods, and then screw in a retention screw.