case for moog infinity feeding pump

ok guys I'll try to make this as simple as possible.  the case i used was the axigear 16x13x6 from amazon(i chose this for it's mostly flat design).  d-ring tie down anchors, and askuko 56 inch shoulder strap(other straps would not fit the d-rings).  lar-me 2 inch rubber grommets.  odontomed2011 6'' stainless plier.  gcode files are good to go for the ender 3.  I had to scale the stl files to work, so I will give you one axis just do uniform scaling.  the velco strap holders I used can be found here https://www.printables.com/model/634010-velcro-strap-20mm-holder.  I have a list of bolts, but you may want to got to your local hardware store and double check the sizes.  I had to reem out the holes on the velcro holders.  everything else was very snug.  

The shopping list

1 ¼ inch 20 tpi x 2 ½ inch (pump bolt)

4 6-32 x ¾ (velcro hangers)

8 ¼ inch x ¾ (bag hangers and pump bracket)

2 10-24 x ¾ (d-rings for shoulder strap)

8 5/32 x 7/8 (washers)

if I missed something let me know.