Backgammon Board

To Print

• 30x pieces, 15 of each if printing in different colors
• 2x large bowties
• 2x small bowties
• 2x board halves
• 2x board halves (mirrored)
• 24x triangles, 12 of each if printing in different colors

To Buy

• These magnets (optional)
• These dice

Printing Instructions

I used magnetic filament for the triangles and painted them with spraypaint afterwards.

Use whatever colors you want and whatever plastic.

A little support material is needed for where the bowties fit in, but not a whole lot.

Assembly Instructions

The magnets should fit in the pieces without any glue. Make sure they're all facing in the same direction so the pieces can stack.

The triangles required a little sanding to get to fit, but not much. No gluing necessary here either.

The bowties needed some expoxy, but that's optional I suppose. I left one half of the board unglued from the other so that it can be removed and folded over and secured with a rubber band for storage