Apple C to barrle overmold

Hot glue overmold to strengthen or repair apple's usb c to headphone jack adapter.

I personally don't like the fact that a lot of these adapter use a flimsy wire between the ports,
with this mod it will be a lot stronger.

make shure to cover all inside surfaces with petroleum jelly

You can use a bit of dish soap to clean this off the finished dongle later.

I recomend to first test the mold without a dongle and time how long it takes for your glue to harden, mine took around 20 minutes to fully harden.

This design does not have any regestration features, I clamped it down and adjusted it a bit until it was aligned propperly.

The top part is a mirror image of the bottom.

Printed on bambu A1
Pla, 0.4 mm nozzle, 0.2mm layer height