Original Prusa Enclosure Lid Prop

I needed a way to hold the lid open when working by myself. Due to my setup, I can't open the lid the way it's probably meant to, so I have to have someone hold it while I'm working in from the top or have the lid sit on my head/back. Sometimes someone isn't always available to help me and it makes it hard to do certain things when I need to use both of my hands and hold the lid up on my head. So I created this! I had other versions in mind, but none of them worked out and they were causing me to use and then therefore waste a lot of filament. I used a piece of PVC pipe that I cut to roughly 22.5in (or 57.15 cm) then I cut a slant at each end. The top was originally meant to sit on the lid/handle , but that didn't work, however using it on the handle itself worked just as well.

PLA

0.2 Speed

No Supports - (flip the models so they sit on correct faces. I added a picture that will hopefully help)

15% infill