Suet Cube Bird Feeder (for Birdfy Pro)

Simplified Suet Ball / Cube for the Birdfy Pro set.

It's a simple cube suet cage. Just big enough for a quarter of a standard sized suet refill. No need to get your hands dirty, just cut off a quarter or two and stack them into the cage.

The top is a simple snap lock which should also make it easier to use when everything is jammed up with seeds and fat.

Two version:

SuetCube-Bottom - With the post to fit the Birdfy Pro set

SuetCube-BottomHole - With a hole instead if you want to use your own mount (also easier to print).

Print the pin if you still want to fit it into the Birdfy set. Either BirbPin1 or BirdPin2 (snap in). That or you can always use an M5 screw (M5x16 with a nut and washer) to secure it to the perch.

Supports are needed. Set the correct filament settings to make sure it's not too string or brittle when building the tall, thin, vertical parts of the cage.

Usually helps to sand the lip and snap fits a bit to ensure a good fit.

Print Settings

Printer Brand:

VoronDesign

Printer: 

Voron Trident 300

Category: Outdoor & Garden