Colt_Walker_Revolver

asssy original Colt_Walker_Revolver
579
988
1
9269
updated September 8, 2024

Makes

Comments

Working on it. This should look really nice if I can finish it. Good Job!

However, I have the same question as msabene, plus more.

Here are my questions:
1. Where do 17 & 18 go?
2. Files 14 & 16 are missing. Is this on purpose?
3. It looks like part 03 has to be printed twice, once mirrored so they assemble into the needed part.
4. Not sure where pin 04 goes, any hints?
5. Not sure where pin 15 goes, any hints?
6. There aren't enough "pins/screws" in the files. Should some be printed multiple times or are these the missing 14 & 16.

I'd love to finish this and post the make, but I could use a bit of help.
Thanks.

Great looking model! I am trying to complete this replica but can't figure out where to place parts 17 and 18... Any suggestions? Thanks!

I just have to comment that the finish on this replica looks immaculate. The only layers I can see are on the grip, and even the grip looks like it has grain to the wood. Bravo, beautiful piece.

All comments loaded