@JackyHuang
Awesome! Thanks! :-)
@Squawk_388463 new version is ok, you can try it.
@JackyHuang
It's only a small bridge.. I think it is manageable whiteout the 'blue ribs' in the screenshot. :-)
@JackyHuang
That would be great! Thank you! :-)
@Squawk_388463 Ok, thanks for the suggestion, I will change it and try to print it. The reason I added this is that I don’t want to have internal support. If the effect can be guaranteed, I will upload the model.
@JackyHuang
Thank you for your reply! :-)
I mean, could you remove the 'ribs' with the blue lines? (plz see screenshot)
This way the silica balls can get in between.
And close to the front.
@Squawk_388463 I'm very sorry that I didn't understand your suggestion, can you give me a sketch to illustrate your idea, so that I can refer to your comments for revision.
Awesome design!
Only remark: I think you could do without one between each of ribs you drew to support the ceiling on the way up.
That way the silica gel balls can get in between easier and all the way up to the front of the box. Then it will also be easier to see when the orange balls turn green for re-drying.
Other than that, perfect model!! :-)
(Prusament PETG - Transparent/Clear) (edited)