Headphone holder for Skadis (dovetail system)
Anycubic Mega S
0
October 3, 2022 at 12:04 PM
Original model
Comments
@marcoszas_250890 Glad you like it. I printed it on 0.2mm height which may be why it was a little too tight for you with the 0.3.
Printed this for my Sony headphones and it works great. The two pieces fit together snuggly (I had to use a hammer to put them together). My print settings were:
- 0.3 mm layer height
- With supports (only for the hooks and the bottom part of the headphone holder)
- 20% infill