I printed some of these in Galaxy Black and used the 0.4mm nozzle (where it specifically asks for 0.6) and got horrific jams, so it was the first time I pulled my Bambu apart. The second one was with plain PLA.
I like the model! The triggers rest on the wall just a bit, but the cord doesn't pull the gamepads off the wall. I 'manually' programmed the center stripe (16mm wide) and went with x-box themed colors.
I really like the wall latch, though it's hard to get the tab level I was able to force it flat after I mounted.
I printed some of these in Galaxy Black and used the 0.4mm nozzle (where it specifically asks for 0.6) and got horrific jams, so it was the first time I pulled my Bambu apart. The second one was with plain PLA.
I like the model! The triggers rest on the wall just a bit, but the cord doesn't pull the gamepads off the wall. I 'manually' programmed the center stripe (16mm wide) and went with x-box themed colors.
I really like the wall latch, though it's hard to get the tab level I was able to force it flat after I mounted.
Thanks for the design!!