Numbered Knobs for Standalone Drybox - MMU
0
August 28, 2020 at 4:20 PM
Original model
Comments
Just in case you, or anyone else, is having trouble dialing in the two Prusa plates. One is 300 micron (Micrometer) thinner than the other, so start with either, get it set how you like it. Then add or subtract (depending on which plate you started with) 300 on the dial, fine-tune +- 10. Obviously, wear and tear will impact your plates, so take that into account. (edited)
(deleted)
Thanks for the rating! I found that it was actually a bit easier to tune the textured sheet personally.. Only because any "mis-tuning" would be hidden by the texture. :) Nonetheless, glad to see this worked.
Good design. I took advantage of the MMU2S and printed mine. Now if only I could get my textured plate tuned in properly, the first layer is nowhere as clear as the creator's. So for now, smooth sheet. (edited)