Printed out of PC Blend CF Black using a 0.4mm Obxidian nozzle on my XL. Definitely prints best oriented so the rearward face of the part on the car lays flat on the bed with supports in the space where the carbon shock tower goes (see pic). Those supports popped out for me with very little issue, however I had printed it in other orientations previously with mixed results.
Being printed out of PCCF makes me think it's going to hold up a good while in the application, but if it doesn't then I'll go to PA.
Printed out of PC Blend CF Black using a 0.4mm Obxidian nozzle on my XL. Definitely prints best oriented so the rearward face of the part on the car lays flat on the bed with supports in the space where the carbon shock tower goes (see pic). Those supports popped out for me with very little issue, however I had printed it in other orientations previously with mixed results.
Being printed out of PCCF makes me think it's going to hold up a good while in the application, but if it doesn't then I'll go to PA.