Printed at 0.08mm on their backs. The Rev2 version's spike weapon snapped while removing supports but it should be easy to glue back in place. I've since revised the female paladin to fill in more gaps but otherwise her sword etc... printed out nicely!
Druid and Paladin models are here too. I've since revised the Paladin model to fill in the gaps a bit more as her feet did not survive the print and supports would be a pain to clean out under her cape.
Human rogue female printed on her back and the sword didn't generate 100%Human cleric/paladin female was printed on her back - supports are tricky here and I sliced through her staff - glue can definitely fix this.
I may need to make "chonkier versions" (see dwarf collection) for better FDM print quality but otherwise I'm happy with these. Resin should be nice and I'm excited to see the weather turn so I can turn it out! (edited)
Printed at 0.08mm on their backs. The Rev2 version's spike weapon snapped while removing supports but it should be easy to glue back in place. I've since revised the female paladin to fill in more gaps but otherwise her sword etc... printed out nicely!
Druid and Paladin models are here too. I've since revised the Paladin model to fill in the gaps a bit more as her feet did not survive the print and supports would be a pain to clean out under her cape.
Human rogue female printed on her back and the sword didn't generate 100%Human cleric/paladin female was printed on her back - supports are tricky here and I sliced through her staff - glue can definitely fix this.
I may need to make "chonkier versions" (see dwarf collection) for better FDM print quality but otherwise I'm happy with these. Resin should be nice and I'm excited to see the weather turn so I can turn it out! (edited)