Flux and Solder Paste Dispenser

I have used white PLA in my Anycubic Kobra 2 Pro, and it came out pretty good.
A handy and useful tool.
However, the texture on the bottom face of the liver makes it a little bit harder to print.

Anycubic Kobra 2 Pro
December 28, 2024 at 12:38 AM

Comments

Ctrl + Enter to send Enter to add a new line

@Elektroarzt_599394
Hello, I really appreciate your response, Actually my 3D printer is well calibrated, I think that the build plate wasn't clean back then, However, that small flow doesn't bother me at all, since, at the end, this tool is well designed and works perfectly.
Rarely when I print something that is not designed by me, but when I find something perfect, its just hard to ignore it. So, clearly it just would be a waste of time to redesign it.

Have a nice day, and keep it up, we are waiting for a some new useful tools.

@GreenBit_1562343 Did you use a PEI plate and calibrated your filament before printing? If you have a Bambu Lab printer, run the pressure advance calibration routine and you should have a good bed adhesion with the parts.