I've printed it on natural ASA with 0.6mm nozzle at 0.2mm layer height.
I sanded and painted the stand. That fixed some imperfections in the part probably because it was not optimized for 0.6mm nozzle. (i.e. the front lip just below the dualsense joysticks was too thin for the last layers)
The wings fit just perfectly. I've used screws to fix them to the stand as I have plenty of them spare.
As for the rubber feet, I printed them myself with some flex filament (30D shore) and they do the job.
I've printed it on natural ASA with 0.6mm nozzle at 0.2mm layer height.
I sanded and painted the stand. That fixed some imperfections in the part probably because it was not optimized for 0.6mm nozzle. (i.e. the front lip just below the dualsense joysticks was too thin for the last layers)
The wings fit just perfectly. I've used screws to fix them to the stand as I have plenty of them spare.
As for the rubber feet, I printed them myself with some flex filament (30D shore) and they do the job.
A very nice part overall!