Scraper for Build Plate - Version 2
0
April 3, 2022 at 10:21 PM
Original model
Comments
@kaje Thanks for the tip, hadn't thought about that. :) Not that i would throw a slightly damaged one away, i would keep it for when it would be useful for something else.
@Ornotermes Note that you can "re-sharpen" the edge by honing it on a bit of sandpaper. I'm still using the one I printed two years ago.
Handy print to have a few of, they get a bit jagged when removing stuck prints so always good to print a spare at the end of a spool.