Telescoping Pencil Holder for 110 or 75 Pencils
Creality Ender 3 V3 SE
0
July 20, 2024 at 5:49 PM
Original model
Comments
@raybetter_104737 sounds good! if I ever need to print a second, or if i need to replace this one at any point, I will try it! Good luck in the collapsables contest!
@SnarkDADmin_1828737 Thanks for the feedback. As someone else mentioned the tolerances were too tight, I will be making some variants that are a little looser *and* a little tighter.
I initially posted my make on the wrong model. I printed this and my daughter loves it. The tolerances are almost a little *too* loose, because i've had some trouble with parts popping out of place/not functioning quite right even though I used a filament where I normally have the opposite issue. That could be error on my part though, so it would be unfair of me to rate it any lower than the 5 stars this model deserves. It's very fun while being practical.