Tried with 0.6mm CHT nozzle, test print worked but not full sword. This sent me in another rabbit hole to make it work!
I discovered that when using 'Arachne' wall generator with OrcaSlicer to give a lot issues with this design. Classic wall generator was a must for my situation.
Replaced CHT 0.6 nozzle to normal 0.4mm Brass nozzle and dozens of test prints later, and calibration retractions.... I managed eventually to print this in place with: - Sunlu PETG - 50mms outerwall speed - 0.43 line width - 0.25 layer height - moderate cooling - in 6,5 hours
Very nice design, and thank you for sharing!! I got to learn more from this print, a win win :D (edited)
Tried with 0.6mm CHT nozzle, test print worked but not full sword. This sent me in another rabbit hole to make it work!
I discovered that when using 'Arachne' wall generator with OrcaSlicer to give a lot issues with this design. Classic wall generator was a must for my situation.
Replaced CHT 0.6 nozzle to normal 0.4mm Brass nozzle and dozens of test prints later, and calibration retractions.... I managed eventually to print this in place with:
- Sunlu PETG
- 50mms outerwall speed
- 0.43 line width
- 0.25 layer height
- moderate cooling
- in 6,5 hours
Very nice design, and thank you for sharing!! I got to learn more from this print, a win win :D (edited)