This was a pleasure to print. No supports needed, everything printed smoothly and turned out very beautiful. I painted the eye with Tamiya transparent orange glue. I used red led strip on the bottom and 1 led bulb with 500ohm resistor in the eye (I used a red bulb and regretted it, if you plan to paint the eye then use white bulb). The cables were exposed on top so I painted them black to blend them in. I have designed a bottom panel to cover the electronics if you plan to use lights but the remix is not allowed. Basically what I did was that I used prusaslicer's tool to cut small portion of the base(about 2mm). then I used small cubes to fill the gaps and then I glued the printed piece (edited)
This was a pleasure to print. No supports needed, everything printed smoothly and turned out very beautiful. I painted the eye with Tamiya transparent orange glue. I used red led strip on the bottom and 1 led bulb with 500ohm resistor in the eye (I used a red bulb and regretted it, if you plan to paint the eye then use white bulb). The cables were exposed on top so I painted them black to blend them in. I have designed a bottom panel to cover the electronics if you plan to use lights but the remix is not allowed. Basically what I did was that I used prusaslicer's tool to cut small portion of the base(about 2mm). then I used small cubes to fill the gaps and then I glued the printed piece (edited)