Nice! Super handy and a very easy print, even with a 0.6mm nozzle. Had to go down to a 0.66mm extrusion width for the threads, but it went without a hitch. Had some light overhang difficulty on the nut, but that was likely due to the temperature rather than anything else.
Nice! Super handy and a very easy print, even with a 0.6mm nozzle. Had to go down to a 0.66mm extrusion width for the threads, but it went without a hitch. Had some light overhang difficulty on the nut, but that was likely due to the temperature rather than anything else.
Printed out of Orange Polymaker Polyterra.
Settings:
- 0.66mm Extrusion Width
- 0.15mm layer height
- 3 shells
- 12 surfaces (top / bottom each)
- 0.6mm nozzle
- 25% infill