Cockpit Phone Holder Clip v2
Prusa MK3/S/S+
0
April 30, 2024 at 1:23 PM
Original model
Comments
@RealNationPrint It's pretty stable at 1.0mm, but I might try to kick it up to 1.2mm to get more strength in the clamps. Never gone to 1.2mm before, so we shall have to see.
@hitchhiker4200 looks good but i think its not strong enough? and not stable enough? But thanks for the Feedback i will try it out, in den next days.
Prints well in vase mode if you crank up the line width to about 1.0mm and trim the top and bottom of the part a few layers back.