I did end up using Blender to separate the korok from the backpack so that I could print them in different filament. So if the korok looks a little off center in my pics, that is because it is. (later I found other models on thinkiverse that are already separate so .. should have done that instead). anywho. I like the idea of a piggy bank but the bottom plug is not great. It is hard to grip. I also edited it to make a hole for a penny to be used to turn it, but I think now technically coins could fall out of it. I think it needs a completely different type of plug to be honest. or a much thicker plug to allow for a slot for a penny to use as a turn key that does not go all the way through it.
Also this prints pretty small at 100% so you will want to bump that up a bit. I also used support structures for the acorn and cup. You will need support for the korok too.
In both pictures, most of the model was painted with the exception of the korok (Ziro Matte Matcha). The smaller one was printed in brown matte (polytera matte) and most of the main bag on that one is unpainted.
I use Angelus leather paint on my models because it is also listed for vinyl and i think it actually paints on plastic really well and looks good.
I did end up using Blender to separate the korok from the backpack so that I could print them in different filament. So if the korok looks a little off center in my pics, that is because it is. (later I found other models on thinkiverse that are already separate so .. should have done that instead). anywho. I like the idea of a piggy bank but the bottom plug is not great. It is hard to grip. I also edited it to make a hole for a penny to be used to turn it, but I think now technically coins could fall out of it. I think it needs a completely different type of plug to be honest. or a much thicker plug to allow for a slot for a penny to use as a turn key that does not go all the way through it.
Also this prints pretty small at 100% so you will want to bump that up a bit. I also used support structures for the acorn and cup.
You will need support for the korok too.
In both pictures, most of the model was painted with the exception of the korok (Ziro Matte Matcha). The smaller one was printed in brown matte (polytera matte) and most of the main bag on that one is unpainted.
I use Angelus leather paint on my models because it is also listed for vinyl and i think it actually paints on plastic really well and looks good.