Prints just fine. The 100% model is pretty small so I suggest scaling up a bit unless you want a tiny llama. Also I think this looks more like an alpaca but that is my opinion. I believe I may have used a little paint-on support (only on the smaller 100% print) for a small leg part that didn't have a lot of contact with the plate, just to make sure it didn't pull up. Otherwise you could use a brim but it can be hard to remove because it will fill in the areas between the legs.
Prints just fine. The 100% model is pretty small so I suggest scaling up a bit unless you want a tiny llama. Also I think this looks more like an alpaca but that is my opinion.
I believe I may have used a little paint-on support (only on the smaller 100% print) for a small leg part that didn't have a lot of contact with the plate, just to make sure it didn't pull up. Otherwise you could use a brim but it can be hard to remove because it will fill in the areas between the legs.
Filament: polytera matte rainbow