Printed the narrow version in PETG (put a lighter next to it for size comparison), fits perfectly. I actually had quite a hard time finding some M2.5 screws that were long enough - in the end I found some at an old SUB-D plug's housing. They still were a bit too short, so I drilled out the mounting holes from the bottom about 6mm deep to take up the screws - worked great :) Thanks!
Printed the narrow version in PETG (put a lighter next to it for size comparison), fits perfectly.
I actually had quite a hard time finding some M2.5 screws that were long enough - in the end I found some at an old SUB-D plug's housing. They still were a bit too short, so I drilled out the mounting holes from the bottom about 6mm deep to take up the screws - worked great :)
Thanks!