Meta / Oculus Quest 2 VR Gunstock / Stock
Sovol SV06
0
February 20, 2024 at 10:32 PM
Comments
@JaiSingh_666200 as a bonus point, to increase strength, you can place it on the side and cut 2mm from the bottom. This will create wery stiff and easy&fast to print rod. I did it this way, still using it since, had zero issues.
@JaiSingh_666200 Sure, im usign orca slicer, so ive just created a cylinder and resized it to fit. This is good enough and will work, i guess other slicers have similar features, cura have a plugin for a basic primitives.
@pusni_rizda Can you please provide the files for the rod print? Or just like the measurements, so I can do something similar? (edited)
Printed one out of petg, also printed a basic rod for it.
I don't sure about other games but for Pavlov it's not a great fit, angle is way to tight and handling it like that hurts your dominant hand. However, i like the idea, it brings a lot of stability in you aim overall.
Also i don't find it easy to print, t3dhvrgunstockforev6.3mf is tends to warp a little because of low point of contact so i forced not only to add brim but also cut it a little for increasing adhesion.
Assembled using m3 bolts & nuts, not a best fit, but it works. (edited)