Clearance test - a new challenge who unlocks the 0.06 mm clearance nut?
Sovol SV06
0
January 3, 2024 at 10:47 PM
Comments
@pusni_rizda Congratulations, especially because that is not a heavily under-extruded print, on the contrary the surfaces look gorgeous without the slightest gap!
Printed it using 0.6 cht clone nozzle with 0.3 layers first time out of PLA at about 90-100mm/sec.
I'm a bit surprised it actually works. 0.06 is a slightly stiffer compared to other parts, but still easily movable without any cracks.
Not trickery used, just my well tuned default settings i use every day.