Printed in Prusament PETG Anthracite @ default 0.2 Quality setting.
Not sure if it can be printed upright without supports. The square ports need some cleanup this way, but it's fine for me.
Close fit, but you can print it sequentially this way (to reduce stringing and more efficient movement). Just place it as far to the front and back as possible, I had about 1 cm clearance to the x axis (lucky this time ;D). (edited)
Update: There is an improved version with print instructions on the Github page:
https://github.com/kubesail/pibox-case
Printed in Prusament PETG Anthracite @ default 0.2 Quality setting.
Not sure if it can be printed upright without supports. The square ports need some cleanup this way, but it's fine for me.
Close fit, but you can print it sequentially this way (to reduce stringing and more efficient movement). Just place it as far to the front and back as possible, I had about 1 cm clearance to the x axis (lucky this time ;D). (edited)