Articles

stolni ikea skadis

Šnvać 24
Šnvać
@snvac_hrvat_je
ikeaikeaskadis
February 14, 2026
1 min
37
Image for stolni ikea skadis

Stolni IKEA Skådis – moj mali upgrade koji stvarno radi posao

Ako koristiš IKEA Skådis na stolu, znaš da je super stvar al' isto tako znaš da mu fali par praktičnih dodataka. Upravo zato sam napravio ovaj model koji je jednostavan i koristan dodatak koji rješava ono što Skådis sam po sebi ne može.

Za koga je ovo?

Za sve koji rade na stolu i žele da im stvari budu posložene. To znači da se sviđa makerima, modelarima, 3D printer ekipama, studentima, svima koji vole red al' bez kompliciranja. Veza za moj model:  https://www.printables.com/model/1599873-stolni-ikea-skadisdesktop-ikea-skadis

ikeaikeaskadis

Comments

█

█

█

█

█

█

█

█

█

█

Recommended articles

Printables 3
Printables
@Printables
Image for Designer of the Month: July
Designer of the Month: July
Each month, we pick one creator from the Printables community and give them a bit more space: to show their models, talk about how they design, and choose a theme for a community challenge. It is a way to say thanks, but also a way to show the real p
July 2, 2026
10 min
25
6
1,212
soozafone 24
soozafone
@soozafone
Image for Introducing Carbon 13!
Introducing Carbon 13!
It's been more than two years since I released Dummy 13 here on Printables. That was the culmination of what I called the “13 Series,” a set of models allowing anyone to customize their own humanoid action figure.
Since then, I've explored in a few d
February 13, 2026
4 min
1.1K
157
21,081
suit 22
suit
@suit
Image for CORE One Mini - The Rocky Road to a Prototype.
CORE One Mini - The Rocky Road to a Prototype.
Some folks have already seen some of my announcements, updates and discussions about a Prusa CORE One Mini on various platforms like Reddit. After a few setbacks up until November 2025, the project was put back to the drawing board for the third time
July 5, 2026
10 min
313
30
9,684
Martin 33
Martin
@Martin
Image for DHD 1/1 finished!
DHD 1/1 finished!
Greetings everyone. So, after more then 4 months of work, the DHD is finally finished. Or rather my part is done. It is printed and assembled and painted. Now it will go to the customer for the electronic fitting, lights and sounds so that it could b
October 4, 2025
2 min
733
149
13,947