Articles

NEW (and old) NERF Mag fed string blatser!

AKO Division 17
AKO Division
@AKO_Division
cosplaynerfscifi
October 11, 2025
1 min
240
Image for NEW (and old) NERF Mag fed string blatser!

Hello everyone!

The Silica-5 is a Sci-fi looking hand-cannon brick that uses straight Talon mags. The main point of this one is to give higher performance with a longer barrel, string compression and travel. Can hit 100-110 fps. Maybe 120 fps if you make it work somehow.

I've been working on this for too long, as I was quite busy the past months. And now it's done. I'm moving probably to plunger based blaster with even higher performance.

Check this one out if it sparks your interest!

 

cosplaynerfscifitacticalnerfblasterelasticoutdoortoy

Comments

█

█

█

█

█

█

█

█

█

█

Recommended articles

Printables 3
Printables
@Printables
Image for Designer of the Month: July
Designer of the Month: July
Each month, we pick one creator from the Printables community and give them a bit more space: to show their models, talk about how they design, and choose a theme for a community challenge. It is a way to say thanks, but also a way to show the real p
July 2, 2026
10 min
34
15
2,460
suit 22
suit
@suit
Image for CORE One Mini - The Rocky Road to a Prototype.
CORE One Mini - The Rocky Road to a Prototype.
Some folks have already seen some of my announcements, updates and discussions about a Prusa CORE One Mini on various platforms like Reddit. After a few setbacks up until November 2025, the project was put back to the drawing board for the third time
July 17, 2026
10 min
318
30
9,876
soozafone 24
soozafone
@soozafone
Image for Introducing Carbon 13!
Introducing Carbon 13!
It's been more than two years since I released Dummy 13 here on Printables. That was the culmination of what I called the “13 Series,” a set of models allowing anyone to customize their own humanoid action figure.
Since then, I've explored in a few d
February 13, 2026
4 min
1.1K
160
21,518
Martin 33
Martin
@Martin
Image for DHD 1/1 finished!
DHD 1/1 finished!
Greetings everyone. So, after more then 4 months of work, the DHD is finally finished. Or rather my part is done. It is printed and assembled and painted. Now it will go to the customer for the electronic fitting, lights and sounds so that it could b
October 4, 2025
2 min
738
149
14,110