Works really well! regreased alot of my dried up bearings i had leftover!
Works great, thanks. I just had to open up the input hole a bit to fit my particular syringe.
Using this you can setup your F695 bearings the same way that LDO recommends you initially grease your rail carriages: https://docs.ldomotors.com/guides/rail_grease_guide
I also found that an 8 mm socket fits the seals perfectly to push them back in place.
@TominMN_192895 Awesome, thank you for your feedback :)
Works perfectly fine! Has a tight fit, to not slip off the syringe and works even for MGN7 rails
@MNK__284562 Thanks for your feedback :)
Had to use the round ones, as my OCD was screaming trying to perfectly align the triangles :)
Preparing for a Kirigami and read up on Discord these are a good addition. Thank you for the model!
I printed only the retainer ring. It is easy print. Ring has firm connection to skimmer body and floater has better seal without affecting vertical movements. Printed in PETG. Thanks for sharing.
Glad I found this file. I have the very same issue.
Thanks for this! I was just about to crank up CAD and make some mods when I found this.
It doesn't fit into my bestway 4x2m swimming pool: the tube diameter is too big. It can be only partially inserted, I will have to sand it I think.
Even like this, it seems to work (but the effect on a rectangular swimming pool is lower than on a circular one).