tobias 4
tobias
@tobias_25570
published a new model January 22 at 10:14 PM
January 22 at 10:14 PM

Ctrl + Enter to send Enter to add a new line
tobias 4
tobias
@tobias_25570
published a new model May 21, 2023 at 10:45 PM
May 21, 2023 at 10:45 PM

Here's my print with Prusament PTEG. I still need to dial in my printer a bit, but overall I like how it came out. Very clean shape and design for a backpack hanger.

One issue I see is that the upper two holes are over 1.5" apart, which means that screws won't land on a stud if you are mounting against drywall. I might consider remixing with two screws on the vertical axis, one hole printed at an angle in the upper area (through the hanger portion) and another just a bit lower than the original center hole. That would allow you to land the mount on a stud and prevent twisting.

Super cool model though, and perfect if you are mounting it to a wood panel, etc.. (edited)

Fits all backpacks so far perfect! And it is solid and good!

Ctrl + Enter to send Enter to add a new line
All items loaded