The pegs for the pony hooves are a perfect fit. The disk-like base holds up the pony reliably without letting it tip over. This is surprising due to the small size of the base, but it seems the balance is perfect.
The base is not totally flat, so you can use some infill in there. I printed three of these on my Prusa XL with different filaments and infill patterns with each working perfectly.
Most of the ponies in this pose are pretty rare; if you have one you will really want to print this to put the pony on display.
This worked great to hold all my PTFE Hookup Wire! I was lucky enough to have a 3/8" dowel on hand too! Awesomesauce addition to my brand new HCSW System!
I printed three of these on a Prusa XL with generic PETG and it fits their hooves perfectly. This is surprisingly stable.
The pegs for the pony hooves are a perfect fit. The disk-like base holds up the pony reliably without letting it tip over. This is surprising due to the small size of the base, but it seems the balance is perfect.
The base is not totally flat, so you can use some infill in there. I printed three of these on my Prusa XL with different filaments and infill patterns with each working perfectly.
Most of the ponies in this pose are pretty rare; if you have one you will really want to print this to put the pony on display.