stan110 12
stan110
@stan110
published a new model January 18 at 8:31 PM
January 18 at 8:31 PM

Ctrl + Enter to send Enter to add a new line
stan110 12
stan110
@stan110
published a new model November 24, 2024 at 7:19 PM
November 24, 2024 at 7:19 PM

@anchovy_347865 Since I do not have the regular Hadley, I can't say it with certainty. But I think it does not fit. The Neumo used one bold and a printed part to stabilise the rockers. The regular uses 5 bolts.

Ctrl + Enter to send Enter to add a new line
stan110 12
stan110
@stan110
published a new model November 24, 2024 at 7:18 PM
November 24, 2024 at 7:18 PM

Ctrl + Enter to send Enter to add a new line
stan110 12
stan110
@stan110
published a new model October 19, 2024 at 10:37 AM
October 19, 2024 at 10:37 AM

Ctrl + Enter to send Enter to add a new line
stan110 12
stan110
@stan110
published a new model May 27, 2024 at 8:50 PM
May 27, 2024 at 8:50 PM

Exactly what I was looking for. I only used one screw on each side and that seems to have been enough but could also be just because of where I placed it. All in all a great model! Thank you very much!

Ctrl + Enter to send Enter to add a new line
stan110 12
stan110
@stan110
published a new model April 15, 2023 at 11:57 AM
April 15, 2023 at 11:57 AM

Works great with a few of my gridfinity boxes tossed in. Now to get my desk more organized.

Works well and is attractive, overall good print. Not sure if supports are needed under the gridfinity insert portion. Ended up using the supports and it made for a lot of post processing

Ctrl + Enter to send Enter to add a new line
stan110 12
stan110
@stan110
published a new model July 30, 2022 at 1:16 PM
July 30, 2022 at 1:16 PM

Ctrl + Enter to send Enter to add a new line
All items loaded