got to have faith in the prints right lol
@countryskipper obviously you are a very faithful person haha - thanks for the rating and the pics!
I modified the wall mount to make it wider so that I had more adjustment side to side. I replaced two 17 inch monitors with two 22 inch and did not have a way to mount them on the existing hardware. Added these and it works perfectly. I am adding new files with the wider wall mount. I also used M4 heatset inserts
@salatgurke42_452494 Thanks. they only change I'm thinking of is some way to secure them once mounted. Since this is on a moveable stand they can come off, as I found! Great idea with lots of adjustment
It printed fine, however the countersunk hole is too small and I can't find a single screw that would fit. The Logitech C270 fits pretty tightly so if the screw is sticking even a little bit inside, it won't fit.
It might work for some, it might not work for other. Unfortunately it doesn't work for me
@Maikeru Thanks for the rating and constructive criticism! Sorry it didn't work for you. I've just uploaded a new version with a bigger countersink.
Perfect fit for my Makitas. The clearance hole for the screws needed to be drilled out so that a #8 flat head screw could pass through. Great print.
@blernsball Thank you very much! I agree that the clearance holes might be slightly too small for certain screws or drill bits (mine just barely fit through). Might update the model in the future to allow for bigger screws! :)
