I live in the US. Can you upload a version built using inches?
@MatthewHaddoc_776405 I have to make hard math to make this but I can try
I don't get it, I'm trying to get my newly printed sphere to roll around but something is wrong with the world today...
View 2 more comments
@ChuckChance_1060931 and @SHOVELFISH_732901
Expert here. It really is the table... Check detailed instructions under:
https://www.printables.com/model/552792-matching-surface-to-roll-a-low-poly-sphere-on
@ChuckChance_1060931 Call call the table police!! This is a crime against humanity!
Just what I needed while trying to resurrect my ancient drone (DJI used to use like 10 kinds of screws, some very similar, but mixing them up can cause catastrophic failure). Printed perfectly in 0.2. I appreciate small size (finally found a great use for those 15-30g PLA samples)
Handy tool caddy for storage next to the 3D printer at work. The insert is great for tall things like screwdrivers
A bit awkward to take photos of this inside my enclosure, sorry about that =)
Used red transparent PETG, and I had zip ties to match. Using it lets me move the printer further back in my enclosure and actually close the doors without fearing that the tray hits the doors when the print is done.
@JariKomppa_1169265 happy to hear that it worked for you too! Nice match between zip ties and filament :D
Easy to print, doesn't use much filament, and does what it's intended to. I like it, though I'd prefer a version with a larger top part to add weight.