Very good design.
Thank's for sharing ;)

Can you post the configuration/connection settings of repetierserver as well?

Works like a Charm. Thank you! (edited)

Please can you add Protopasta as Vendor as well ? ;)

These things are great!

Hatchbox gray ABS 50% fill, 0.08-mm layer height. With support. I only printed single color.

M3X6 pan head Phillips for the two hold-down and M3X10 pan head Phillips for the screw the pushes the blade forward.
I also used 15 of the cheap M3 heat set nuts from Amazon

Diffuser works great. The bumper I printed and installed does block the view directly from the front some. I'm still able to see it from any angle above and that is helpful. Thank you.

Works perfectly and makes the status LEDs way more visible in a bright room.

Used a clear pla filament and don't know that I'd recommend it for fit and function. But so far loving it.

Pretty sweet, fits nicely, thank you. I printed everything with default settings for the original honeycomb wall. The grid is printed with a combination of Polymaker PLA and DevilDesign PETG, orange inserts are Prusament PETG. Didn't have enough of M3x12 screws, but M3x8 were enough in places where the screws don't go through the acrylic acrylic on the inside (in the corners), and M3x10 were enough where they went through the acrylic. Also didn't have washers so I printed them too.

Printed well

It sounds good. Thanks a lot