A perfect fitting replacement part. Printed out of bambu lab PETG.
But due to its original design its not really suitable for 3d printing. The small "slide-in fins" will definetly brake after a couple uses. Maybe a tpu part will hold up, but I doubt it.
For real 3d printability one should redesign the back of the case plus the clip.
It's holding up for me so far on PETG, but I'll try to improve it at some point. I think I've learned quite a bit since I've designed it, so I hope I'll be able to make it more printable :)
[edit]
Okay, after re-reading your comment I see that I've misunderstood your comment. Well... that's out of the scope for me ;) Maybe I'll be able to improve on the clip somehow to ensure that those fins aren't receiving too much force. (edited)
