hi, any parameters to use? I have Cura and a Ender 3 pro printer
@CamilaDiaz_1297071 I printed with the letters to the sides, and the hole vertical. You must make sure your printer can do the overhang of the curvature of the bead correctly. For me this means:
- low layer height (I used 0.20mm)
- during the overhang printing phase, cooling at 100% and I helped it by putting a ventilator at full speed as well, in the direction of the bed area until the overhang was finished and the beads were printing vertically.
I have not tried to print with supports, cannot speak if that would work better or worse.
If in doubt maybe print a small part as a test? (crop it on the slicer?).
I do not use Cura, I mostly use Bambu Studio and Orca Slicer.
Hi - what did you fill the letters in with?
@Alid_519278 I printed them multi-colour with a multi-colour printer.
@falze_711414 thanks for the photo, well done!
Works great. It exactly matches the available hight of my tool carts (Garant) middle drawer. Need to find the bit set that came with the tool to put it in the dedicated place. Thanks for the design.
@ChristianSch_2186089 glad to hear!
