Printed on a Bambulab A1 in StrongHero Hombre Blue PETG.
Printed vertically with basic tree support and came out perfectly. H-clips worked pretty good, but have a tendency to push apart slightly.
Great model, prints awesome!
If the H-clips are pushing the model apart, check them for elephants foot. If you don't want to re-print them, try filing down the ends of the clip so that they are not contacting the ends of the cavity.
Really nice and good looking print. Printed with no issues or problem. Great model. Printed on Bambu Lab P1S. Working very nice. Printed with Sunlu PLA HIGH SPEED White
Easy to print. Only challenge was gun towers and guns itself, but somehow managed. Thanks for the model.
I like the color changes you did there. Very nice.
For the gun turrets though, I would recommend printing a test turret and then adjusting your xy comp to make the hole tighter or looser. Everyone's printer is a little different so it's hard to make one that fits for everyone right off the bat. It's a tricky part because it needs to be just tight enough to hold on, but loose enough to be poseable. Might take a few iterations of the turret, but it's a small part and shouldn't waste much filament. Good luck.
Pretty much the only printable one piece hull Bismarck available. Printed in 0.25 PETG. Super clean and functional and she GLIDES over water, dead straight. Only changes made were rescaling to 90% wide while maintaining length for cleaner proportions. Super cool!
That's awesome that it floats! I honestly hadn't tried it yet.
I used your flat rock in this Terraforming Mars token to raise the astronauts up to match the dome base for a filament swap. Worked great!
Great use case! Glad it came in handy for you.
I love it!
@levisitts model for the dragon is by MZ4250 btw
https://www.printables.com/model/41499-red-dragon/
Had PROBLEMS with the grooves but it was solved, thanks for the model (edited)
Zero infill works but could use a small internal support as part of the design on the ( in my pics) bottom walls of the model top section is solid based on its design . Just the walls that have the male ends ilends up being slightly soft . I'm also printing at 0.2mm height . But I'm rather enjoying this model if you can't tell .
Turtle sculpt C 02
Printed nice
Looks amazing
Looks good in lip stick red prusament
Love the turtles some of them match my Mississippi map turtle and my pink belly side neck turtle
Thanks for the models
The model has a lot of detail
This is model A printed at 200%
Printed with Hatchbox Silk Gold at .2mm w/ .4
You made a little girl happy with your creation. Thanks! (edited)
That looks great! Hope she likes it.