L.C. 10
L.C.
@lengz_1212791
published a new model December 20, 2024 at 9:10 PM
December 20, 2024 at 9:10 PM

Ctrl + Enter to send Enter to add a new line
L.C. 10
L.C.
@lengz_1212791
published a new model August 5, 2024 at 1:05 AM
August 5, 2024 at 1:05 AM

Ctrl + Enter to send Enter to add a new line
L.C. 10
L.C.
@lengz_1212791
published a new model June 19, 2024 at 11:09 PM
June 19, 2024 at 11:09 PM

Really good fit for Retroid Pocket 4! Printed with PETG and PLA+, had to scale to 99.5 the PLA+ version.

Great design, easy to print from bottom to top with single support. Thanks for share!

Ctrl + Enter to send Enter to add a new line
L.C. 10
L.C.
@lengz_1212791
published a new model March 16, 2024 at 9:18 PM
March 16, 2024 at 9:18 PM

Dimensions are perfect. Only added some tape on the right insight of give it a perfect fit.
Thank you!

Works pretty great! Printed with Cookiecad sunset PLA which pairs nicely with the translucent purple handheld

Ctrl + Enter to send Enter to add a new line
L.C. 10
L.C.
@lengz_1212791
published a new model February 24, 2024 at 2:05 AM
February 24, 2024 at 2:05 AM

Ctrl + Enter to send Enter to add a new line
L.C. 10
L.C.
@lengz_1212791
published a new model February 24, 2024 at 2:02 AM
February 24, 2024 at 2:02 AM

I probably should have printed the version with a glued clip, since this one is a bit rough (cause of supports). Otherwise it is a good fit!

Ctrl + Enter to send Enter to add a new line
L.C. 10
L.C.
@lengz_1212791
published a new model September 23, 2023 at 2:44 AM
September 23, 2023 at 2:44 AM

Ctrl + Enter to send Enter to add a new line
All items loaded