Printed with an Ender 3 v2 with PLA with 60% infill and 1mm walls. I did not need the RGB backlighting to come though, I wanted the case to be pretty sturdy, and I was going to do some pretty heavy sanding.
The printer I used stretched the width of the print by a few millimeters. As such, there's a gap in the bottom edge of the case that I filled in with foam tape. If you look really closely you can see it.
I also made a really janky riser to add an angle to the case. It's just three paint stirrer sticks cut to size and glued together. I put it on the case with double-sided tape and added some silicone edge protector I had lying around for some grip. (edited)
This could theoretically be milled out of aluminium or am I wrong?
Printed with an Ender 3 v2 with PLA with 60% infill and 1mm walls. I did not need the RGB backlighting to come though, I wanted the case to be pretty sturdy, and I was going to do some pretty heavy sanding.
The printer I used stretched the width of the print by a few millimeters. As such, there's a gap in the bottom edge of the case that I filled in with foam tape. If you look really closely you can see it.
I also made a really janky riser to add an angle to the case. It's just three paint stirrer sticks cut to size and glued together. I put it on the case with double-sided tape and added some silicone edge protector I had lying around for some grip. (edited)