KipzRW 8
KipzRW
@kipzrw_1210940
published a new model December 9, 2024 at 8:39 PM
December 9, 2024 at 8:39 PM

Ctrl + Enter to send Enter to add a new line
KipzRW 8
KipzRW
@kipzrw_1210940
published a new model February 2, 2024 at 10:52 PM
February 2, 2024 at 10:52 PM

Thanks works great.. only if I did not have to cut the cameras plastic.. other than that perfect

@danoreindl_503299 which part of the plastic did you have to cut? I don't believe I ever had to modify the camera case for this to work?

Edit: I remember now which part. Yeah that would be ideal but when I made the model my experience with modeling was pretty basic. The part you cut off isn't visible though so externally it's fine. (edited)

Ctrl + Enter to send Enter to add a new line
KipzRW 8
KipzRW
@kipzrw_1210940
published a new model October 2, 2023 at 8:24 PM
October 2, 2023 at 8:24 PM

Bit new to 3d priinting and have Mainly having print quality trouble with big prints

What does this say about my printer what should I do now?

@superEGElord_1528572 each square can be seen as a point within the auto level feature. In short, you can see if each square needs additional Z tweaks in the bed mesh to get a better result on your bed level.

My 2 week old Ender 3 V3 SE was printing really well (on PLA). Today I've tried some PETG and nothing but problems. I've finally managed to get it to print, with the temp of the nozzle higher than the manufacturer recommended temp. I also reset the settings as it appeared my bed was way off. I've now got it to here. What can I do to improve this further? It's random squares, so it's not like one side or corner is off or anything. Can I adjust the individual rough looking points without adjusting the others? (Obv I used the remix)

Just to add, this is so good, thank you

Thanks

Ctrl + Enter to send Enter to add a new line
All items loaded