jjohan 10
jjohan
@jjohan_1599099
published a new model January 12, 2024 at 6:53 PM
January 12, 2024 at 6:53 PM

Works wonderful!
Funciona maravillosamente

easy to print and fits my saws perfectly

Ctrl + Enter to send Enter to add a new line
jjohan 10
jjohan
@jjohan_1599099
published a new model January 3, 2024 at 1:04 PM
January 3, 2024 at 1:04 PM

Printed using Nobufil matte black

The charger holder was printed using:
nozzle: 0.4mm
layer height: 0.2mm
Perimeters: 5 (this needs to be strong and this amount eliminates need for infill)

Bottom part of the dock should be printed laying on a side, so when mounted the layers are vertically aligned. This helps to ensure the print will bear the weight of the battery.

For printing with 0.4mm nozzle:
Layer height 0.2mm
Perimeters: 4
Supports: organic
Infill: 25% cubic

For printing with 0.6mm nozzle (less pretty, but will be stronger):
Layer height 0.3mm
Perimeters: 3
Supports: organic
Infill: 25% cubic

When mounting to any wall or closet:
Place and fasten the charger holder and bottom dock first. Use a bubble level to help.

Then assemble the top part of the dock and plug it in to your battery. Place some double-sided tape behind the top part, then put the battery on the bottom half tilting it until it sits perfectly vertical on the bottom part. Press the top part against the surface you want, then while holding this part remove your battery. Finally fasten with screws.
This approach seems elaborate, but will result in being able to easily mount the battery every single time with only minimal force needed. (edited)

Ctrl + Enter to send Enter to add a new line
jjohan 10
jjohan
@jjohan_1599099
published a new model December 27, 2023 at 9:21 PM
December 27, 2023 at 9:21 PM

Ctrl + Enter to send Enter to add a new line
All items loaded