I've been using the heck out of this thing so thanks! One request, would it be possible to release a file with the handle turned 90deg, it would be very helpful when using flat turning tools that come straight up or down from the keyway.
Noticed this myself so added 5mm spacers above a washer and below the spring then 5mm longer bolts.
Good mod though, definitely an improvement
View 5 more comments
@human I will give it a go at 100 on the bed, I am using a textured PEI magnetic sheet (same as my 3 Max which I printed all the parts on) so I know that's good.
Worst case something melts, it will force me to re-design the bed mount part sooner
I am thinking a sheet of cork might be a smart move between the 2 with the screwholes/sping area cut out to allow fitting easier
What power supply do you use to support the heat bed?
@Gabriel_548796 MEAN WELL LRS-350-24 350.4W 24V
Changed the mounts for a pi zero and skr e3 v3. The rest of it fits great and much nicer solution compared to bottom mount electronics.
Just an FYI - This mount does not fit the Ender 3 v2 hotend. If anyone knows one that does, please let me know
