This works great to holds rolls of tape and stuff like that!
Was a bit fiddly to get on so i had to cut a bit of the bottom pin off but fits in good!
Printed this at 10% infil with some elegoo PLA took 10 minutes and came out with a great finish
Thanks, Matt!
I aimed for a press-fit tolerance, but it might be a bit too tight for your setup.
I'm still not completely satisfied with the design, as the hook tends to sag under heavier loads. I’ll adjust the hook angle to compensate for the sag and improve stability.
I appreciate your feedback—it helps me refine the design!
Fantastic Build! Thank you for all the fixes to the model. Now with the zNext, let's see what changes externally :-)
Part 1 printed flawless, but Part 2 (and probably 3 and 4) will not print properly I guess mostly because of this overhangs that can´t be mitigated with support or anything else. So The first layer always fails. Any suggestions?
View 4 more comments
@hjembaek I will try those! Thank you (it will take a while, I'm printing a 12 hour model now) I will keep you informed!
@96ToyotaCamry_154188 I can recommend to use the highest layer height for your nozzle to save time. It is a very challenging print.
Sending you good luck 🍀😉👍
Absolutely amazing! Thanks hjembaek for making the 3mf available so quickly! Installed the speakers this weekend and just added the logos. Need to clean the car but sharing pics anyways. Thanks again!
@NavinJayaram_2461725 looks great - enjoy the new speakers 😉👍